Nady Systems GEQ131 Manuel d'utilisateur télécharger pdf (Page 6)

7. IEC Power Cord Receptacle

This is used to connect the AC power source to your equalizer.

Power requirements: 115VAC, 60Hz

CAUTION: For new installations and portable sound systems,

or in any situation in which the AC power is suspect, it is wise to

confirm appropriate voltage and line polarity BEFORE connecting

the instrument to the power source.

8. Fuse Holder

This fuse holder contains an AC primary fuse. This fuse should be

replaced with the same type fuse when this is blown out. If they

continuously blow, stop replacing the fuse and refer servicing to

qualified personnel.

CAUTION: After checking the AC supply voltage, be sure that the

correct fuse is in the fuse holder. A 20mm glass tube 500mA 250V

fast-blow fuse should be used.

9. Input/Output Connectors

Balanced XLR and 1/4” TRS Inputs and unbalanced output jacks

for line level operation. Line level signals from - 18dBu to +18dBu

are considered normal. Do not directly connect microphones into

the equalizers. Microphones require a pre amp.

Note: Only one input and one output connector should be used at

a time.

Rear Panel Controls & Connections

7 9

1 2 3 4 5 6 7 8 9 10

Pas de commentaire

Nady Systems GEQ131 Manuel d'utilisateur Page 6