Nady Systems DKW1HTASYS115 Manuel d'utilisateur télécharger pdf (Page 2)

(U.S.) Should your Nady DKW-1 Wireless Microphone System require service, please contact the Nady Customer Service

Department via telephone: (510) 652-2411 or e-mail: ser[email protected].

(INTERNATIONAL) For service, please contact the Nady distributor in your country through the dealer from whom you

purchased this product.

The warranty card supplied with this system provides valuable warranty and service information. Store it in a safe place

for future reference. Do not attempt to service this unit yourself as it will void your warranty.

C. WLT-14 LAVALIER/LAPEL OR HEADWORN MICROPHONE BODYPACK TRANSMITTER

1. Snap open the BATTERY COMPARTMENT (13) and insert a fresh 9V BATTERY (14), observing the correct polarity.

Close the compartment.

2. The WLT-14 is provided with a 3.5mm LOCKING JACK (18) for connecting the microphone. Plug in either the

LAVALIER/LAPEL (19) or the HEADWORN MICROPHONE, as supplied. To secure the connection, turn the metal slip

ring on the plug clockwise to thread it on to the jack. To unplug, reverse the process. Slip the transmit

ter into a pocket or clip on to your clothes. To use the lavalier mic, attach it at chest level. Do not place too close to

the mouth—a distance of about six inches usually works best. To use the headworn mic, place it on the head and

adjust the mic boom so that the mic is about one inch to the side of the front of the mouth. (

Note: the lavalier or

headworn mic wire is also the transmit antenna, and rolling up or shortening the wire may reduce the effective

operating range. Extend the wire fully during use, and keep it as straight as possible.)

3. Turn on the WLT-14 by sliding the OFF/MUTE/ON SWITCH (15) to the MUTE position (transmitter on, audio

muted) or the ON position (transmitter and audio both on). The BATTERY INDICATOR LED (16) will give a single

quick flash, indicating usable battery strength. In the case of a dead or low battery, the LED either will not go on at

all or will stay on continuously, indicating that the battery should be replaced with a fresh one.

4. The microphone is now ready to use. The TRANSMITTER SIGNAL RECEIVED LED (5) on the DKW-1 receiver should

now be lit. When ready to speak, slide the transmitter switch to the ON position and adjust the mixing board volume

level as needed.

[Note: Observe care in selecting P.A. volume, transmitter location and speaker placement so that

acoustic feedback (howling and screeching) will be avoided. Please also observe the pickup patterns of the

microphone selected: omnidirectional mics pick up sound equally from all directions and are prone to feedback if

not used carefully. Unidirectional mics are more resistant to feedback, but pick up sound sources best that are

directly in front of the mic. Also, mics that are farther from the sound source, such as lavaliers, require more

acoustic gain and thus are also more prone to feedback than close-source mics such as handheld or headworn mics

that are used close to the mouth.]

5. For optimum performance, an AUDIO INPUT LEVEL CONTROL (17) is provided. Adjust the microphone gain with a

small slot-head screwdriver. Set for maximum possible gain without noticeable distortion on the high level peaks.

Turning the trim control clockwise increases the audio level; turning it counterclockwise decreases the audio level.

Experiment for the best sound for your application. The AUDIO PEAK LED (4) will flicker on the receiver with audio

peaks on the microphone input. This is normal. If the indicator lights continuously, it means the signal is too loud and

there is the possibility of overload distortion. Re-position the microphone farther from the source or adjust the AUDIO

INPUT LEVEL CONTROL (17) until the indicator flickers only on the loudest inputs.

SERVICE

Nady Systems, Inc.

6701 Shellmound Street

Emeryville, CA 94608

www.nadywireless.com

WLT-14

Opening Battery Compartment

1 2

OPERATING INSTRUCTIONS 1
SERVICE 2

Commentaires sur ces manuels

Pas de commentaire

Nady Systems DKW1HTASYS115 Manuel d'utilisateur Page 2

Commentaires sur ces manuels

Produits connexes et manuels pour Microphones Nady Systems DKW1HTASYS115